8.Set the computer to the same parameters as the printer. On many computers this can be done by setting DIP switches before power is turned on. Another method is as follows:
In DOS, enter the following commands:
C:>MODE COM1:96,N,8,1,P
C:>MODE LPT1:=COM1
To test the interface, then enter:
^P (Press the P key while holding down the Ctrl key.) C:>DIR
^P (Press the P key while holding down the Ctrl key.)
The software settings made by the procedures above are temporary. On most computers, permanent settings must be made with DIP switches.
If you want to use a different baud rate or change any of the other
