Lantronix 900-607 manual Figured, Line 2 line2 level commands

	5: Commands and Levels
show line	Displays the current configuration.
show statistics	Shows the line statistics.
state disable	Disables the line so data cannot be sent/received.
state enable	Enables the line so data can be sent/received.
stop bits 1	Uses one stop bit after data on the line.
stop bits 2	Uses two stop bits after data on the line.
terminal <line>	Enters the configure-terminal level.
	<line> = number of the terminal line (serial port) to be con-
	figured.
terminal network	Enters the configure-terminal level for the network.
termination disable	Refrains from terminating the line.
termination enable	Enables 120 ohm line termination in RS485 half-duplex
	mode.
threshold <bytes>	Sets the threshold in bytes. After this many bytes are re-
	ceived, they are
	forwarded without delay.
tunnel <line>	Enters the tunnel level.
	<line> = number of the tunnel line (serial port) to be confi-
	gured.
write	Stores the current configuration in permanent memory.
xoff char <control>	Sets the xoff character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
xon char <control>	Sets the xon character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
line 2 (line:2) level commands
auto show statistics	Continuously displays line statistics.
baud rate <bits per second>	Sets the line speed.
	<bits per second> = the speed.
	Standard speeds include 1200, 2400, 4800, 9600, 19200,
	and so on.
clear line counters	Sets the serial counters to zero.
clrscrn	Clears the screen.
command mode always	Sets the current line to always be in command mode.
command mode echo serial string disable	Disables user-defined serial boot string to be echoed in
	the CLI.
command mode echo serial string enable	Enables user-defined serial boot string to be echoed in the
	CLI.
command mode serial string	Enables user to enter a custom string at boot time to enter
	command mode.
command mode serial string <string>	Sets a string that can be entered at boot time to enter
	command mode.
	<string> = text with possible binary characters.
	Within [] use binary decimal up to 255 or hex up to 0xFF.
	Within {} specify decimal milliseconds time delay.
command mode signon message <string>	Sets a sign-on message that is sent from the serial port

PremierWave XN Command Reference 148