Lantronix 900-607 manual Link config-wlanwlan0 level commands, Choice instance

	5: Commands and Levels
show history	Displays the last 20 commands entered during the current
	CLI session.
show line	Displays the current configuration.
show statistics	Shows the line statistics.
state disable	Disables the line so data cannot be sent/received.
state enable	Enables the line so data can be sent/received.
stop bits 1	Uses one stop bit after data on the line.
stop bits 2	Uses two stop bits after data on the line.
terminal <line>	Enters the configure-terminal level.
	<line> = number of the terminal line (serial port) to be con-
	figured.
terminal network	Enters the configure-terminal level for the network.
termination disable	Refrains from terminating the line.
termination enable	Enables 120 ohm line termination in RS485 half-duplex
	mode.
threshold <bytes>	Sets the threshold in bytes. After this many bytes are re-
	ceived, they are
	forwarded without delay.
tunnel <line>	Enters the tunnel level.
	<line> = number of the tunnel line (serial port) to be confi-
	gured.
write	Stores the current configuration in permanent memory.
xoff char <control>	Sets the xoff character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
xon char <control>	Sets the xon character for use with software flow control
	on this line.
	The character may be input as text, control, decimal, or
	hex.
	A control character has the form <control>C.
	A decimal value character has the form \99.
	A hex value character has the form 0xFF.
link (config-wlan:wlan0) level commands
active channel scan time <milliseconds>	Sets the active channel scan time in milliseconds.
apply wlan	Try out WLAN settings without saving them to Flash.
	If the settings do not work, when you reboot the device,
	it will still have the original settings.
cancel wps	Cancels wi-fi protected setup operation.
choice <instance>	Enters the next lower level.
	Specify the instance for the next lower level.
clrscrn	Clears the screen.
debugging level debug	Sets the WLAN debugging level to Debug.
debugging level dump	Sets the WLAN debugging level to Dump, the most ver-
	bose option.
debugging level error	Sets the WLAN debugging level to Error, which shows
	only errors.
debugging level info	Sets the WLAN debugging level to Info.
debugging level warning	Sets the WLAN debugging level to Warning.
default active channel scan time	Restores the default active channel scan time.
default debugging level	Sets the WLAN debugging level to its default value, Info.

PremierWave XN Command Reference 150