Figure 19. Screws that secure the heat sink and fan assembly
7.Lift the heat sink and fan assembly off the system board.
Notes:
a.You might have to gently twist the heat sink and fan assembly to free it from the microprocessor.
b.When handling the heat sink and fan assembly, do not touch the thermal grease on the bottom of the heat sink and fan assembly.
8.Place the new heat sink and fan assembly on the system board so that the four screws are aligned with the corresponding holes in the system board. Make sure that you properly place the new heat sink and fan assembly so that you can easily connect the new heat sink and fan assembly cable to the microprocessor fan connector on the system board.
9.Follow this sequence to install the four screws to secure the new heat sink and fan assembly, as shown in Screws that secure the heat sink and fan assembly:
a.Partially tighten screw
b.Partially tighten screw
1 , then fully tighten screw
3 , then fully tighten screw
2 , and then fully tighten screw
4 , and then fully tighten screw
1.
3.
10.Connect the new heat sink and fan assembly cable to the microprocessor fan connector on the system board. See “Locating parts on the system board” on page 8.
Chapter 2. Installing or replacing hardware 23
