5.Hold the hard disk drive and remove the four screws that secure the hard disk drive. Then, remove the hard disk drive from the drive bay assembly and disconnect the signal cable and the power cable from the rear of the hard disk drive to completely remove it from the chassis.

Figure 34. Removing the hard disk drive

6.Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an available SATA connector on the system board. See “Locating parts on the system board” on page 8. Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.

Figure 35. Connecting a SATA hard disk drive

36ThinkCentre User Guide

Page 42
Image 42
Lenovo 804 manual Removing the hard disk drive