Lenovo M73 manual Installing the solid-state drive into the storage converter

3.Position the solid-state drive into the storage converter so that the holes in the drive are aligned with the corresponding holes in the converter. Then, install the four screws to secure the solid-state drive to the converter.

Figure 26. Installing the solid-state drive into the storage converter

Replacing the solid-state drive on the bottom of the optical drive bay

To replace the solid-state drive on the bottom of the optical drive bay, do the following:

1.Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.

2.Remove the computer cover. See “Removing the computer cover” on page 38.

3.Remove the front bezel. See “Removing and reinstalling the front bezel” on page 38.

4.Pivot the drive bay assembly upward. See “Accessing the system board components and drives” on page 40.

5.Disconnect the signal cable and the power cable from the solid-state drive.

50ThinkCentre M73 User Guide