4044-XXX
The fuser lamp does light
FRU | Action |
|
|
Model 310 | If the fuser lamp comes on and a |
Thermistor | fuser failure LED error code displays, |
| be sure the thermistor is contacting |
| the hot roll and the thermistor cable |
| is firmly seated in connector CN1 on |
| the LVPS board. Check for excessive |
| toner buildup on the surface of the |
| thermistor. Clean or replace as |
| necessary. Turn the printer off and |
| disconnect the thermistor cable from |
| CN1 on the LVPS board. Measure |
| the resistance of the thermistor |
| between |
| resistance measures approximately |
| 225K ohms when cool. Replace the |
| thermistor as necessary. |
|
|
Model 312 | If the fuser lamp comes on and a |
Thermistor | fuser failure LED error code displays, |
| be sure the thermistor is contacting |
| the hot roll and the thermistor cable |
| is firmly seated in connector CN10 |
| on the engine board. Check for |
| excessive toner buildup on the |
| surface of the thermistor. Clean or |
| replace as necessary. Turn the |
| printer off and disconnect the |
| thermistor cable from CN10 on the |
| engine board. Measure the |
| resistance of the thermistor between |
| |
| measures approximately 225K ohms |
| when cool. Replace the thermistor |
| as necessary. |
|
|
Models E310 & E312 | Make sure the correct voltage lamp |
Fuser Lamp | is installed. The voltage rating is |
| stamped on one of the lamp |
| contacts. |
|
|