INSTALLATION | ||
|
|
|
WIRE DRIVE SYSTEMS
Drive Roll Kits are designed to feed specific types and wire sizes. The Power Feed™ 10M Single Wire Feeder does not include these Drive Roll Kits with this Wire Drive, but are available for ordering from the fol- lowing tables:
Drive Roll Kits, Steel Wires
Includes: 4 Smooth V groove drive rolls and an inner wire guide.
|
| ||
| .035 (0.9mm) | ||
| .040 (1.0mm) | ||
| .045 (1.2mm) | ||
| .052 (1.4mm) | ||
| 1/16 (1.6mm) | ||
CHANGING DRIVE ROLLS AND WIRE GUIDES
FIGURE A.4
1
2
3
Drive Roll Kits, Cored Wires
Includes: 4 Knurled drive rolls and an inner wire guide.
|
| ||
|
| ||
|
| .052" (1.4mm) | |
|
| 1/16" (1.6mm) | |
|
|
|
|
| Drive Roll Kits, | Steel or Cored Wires | |
Includes: 4 Knurled drive rolls and an inner wire guide.
|
| ||
|
| 5/64" (2.0mm) | |
|
| 3/32" (2.4mm) | |
|
| 7/64" (2.8mm) | |
|
| .120" (3.2mm) | |
|
|
|
|
| Drive Roll Kits, | Hardfacing Wires | |
Includes: 2 Knurled drive rolls, 2 Smooth V groove drive rolls and an inner wire guide.
7/64" (2.8mm) |
Drive Roll Kits, Aluminum Wire
Includes: 4 polished U groove drive rolls, outer wire guide and an inner wire guide.
.035" (0.9 mm) | |
.040" (1.0mm) | |
3/64" (1.2mm) | |
1/16" (1.6mm) | |
3/32" (2.4mm) |
|
| WIRE DRIVE DOOR |
|
| (OPEN) |
|
|
|
ITEM | DESCRIPTION | |
1 | Inner Wire Guide | |
2 | Drive Rolls | |
3 | Outer Wire Guide | |
To change drive rolls and wire guides:
1.Turn off power at the welding power source.
2.Open wire drive door.
3.Remove the outer wire guide. (Item #3)
4.Remove the 4 drive rolls (Item #2) by pulling them straight off of the drive hub. Rock the upper drive rolls back for ease of removal.
5.Remove the inner wire guide (Item #1).
6.Insert the new inner wire guide (Item #1) over the locating pins of the feed plate.
7.Install each drive roll by pushing it onto the hub until it fully seats.
8.Install the outer wire guide.
9.Swing the upper drive rolls down and close the wire drive door.
