Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR | ||
|
INPUT FILTER BOARD REMOVAL AND REPLACEMENT (continued)
FIGURE F.24 – INPUT FILTER BOARD LOCATION
INPUT FILTER BOARD
PROCEDURE
TOC
TOC
1.Remove input power to the
2.Using a phillips head screwdriver remove the case wraparound cover.
3.Perform the Input Filter Capacitor Discharge Procedure detailed earlier in this section.
4.Locate the input filter board. See Figure F.24.
5.Using a 7mm nut driver, label and remove leads R/L1 and S/L2 from the upper right corner of the input filter board. See Figure F.25.
6.Using a 7mm nut driver, label and remove leads RV1 and RV2 from the left side of the main IGBT board. See Figure F.26. See Wiring Diagram
Return to Section
Return to Section TOC
Return to Master
Return to Master TOC
FIGURE F.25 – INPUT FILTER BOARD LEADS
R/L1
S/L1
