Lincoln Electric SVM 117-A service manual Spool GUN Connection, Spool GUN Preparation

C-4

ACCESSORIES

C-4

TOC

TOC

2.

Strip .50" (12.7 mm) of insulation jacket off the lead

end and slip the supplied copper tube ferrule over

Section

Master

the stripped end.

3. Insert the lead end with ferrule completely into the

to

to

brass Twist-Mate plug and tighten the set screw for

a positive electrical connection.

Return

Return

4. Pull the rubber boot over the plug to insulate the

connection.

SPOOL GUN CONNECTION

TOC

TOC

CAUTION

FIGURE

C.4

-

Spool

Gun

Connection

Box

The spool gun module is intended for use with

Section

Master

Lincoln Electric Magnum Spool Guns only. Use

Installation.

with other units may cause damage to the equip-

7. Route the electrode lead of the connection box up

ment.

For

Spool

Gun operation,

refer to the

to

to

instruction

manual

provided with

the Magnum

through the same opening in the front louver.

Spool Gun.

Return

Return

8. Remove the positive electrode lead from its con-

____________________________________

nection on the wire drive with the machine con-

nected

for

electrode

positive (refer to Output

1. Connect the spool gun control cable 6-pin plug to

Polarity Connection in Installation Chapter).

the mating receptacle on the front of the spool gun

9. Reconnect with the connection box electrode lead

adapter connection box installed during Spool Gun

Box Connection

on the bolt under the positive electrode lead so the

connection

box electrode

lead is sandwiched

NOTE: If using a K469 spool gun with 4 pin plug, use

between the positive electrode lead terminal and

the K518 adapter.

TOC

TOC

the wire drive contact surface.

a.

Tighten snugly being careful not to strip the

2.

Insert the Twist-Mate plug installed when preparing

Section

Master

the spool gun into the mating receptacle on the

threads.

front of the connection box and twist to lock the

to

to

connection.

SPOOL GUN PREPARATION

Return

Return

3. Attach the spool gun gas line to the gas outlet fit-

1. Cut the terminal lug off the end of the spool gun

ting on the front of the connection box.

electrode lead and slip the rubber boot, included in

NOTE:

Refer to the Instruction Manual included with

the kit, over the lead jacket. See Figure C.5.

the K487 or K469 Spool Gun for more details about

Spool Gun set-up and operation.

Section TOC	Master TOC
		FIGURE C.5 - Spool Gun Preparation.
Return to	Return to

WIRE-MATIC 250