Lincoln Electric SVM 117-A service manual Leads

TOC

TOC

F-17 TROUBLESHOOTING & REPAIR F-17

ACTIVE SCR RECTIFIER ASSEMBLY TEST (CONTINUED)

Return to Section

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master

Return to Master TOC

Return to Master TOC

Return to Master TOC

TEST PROCEDURE

1.Disconnect main AC input power to the machine.

2.Disconnect Molex Plugs J3 and J6 from the G2332 Control Board. See Figure F.5.

J3

WM-250 CONTROL

G2332

J9

J6

J4

J5

J1 J7 J10

J2

FIGURE F.5 - Control Board Molex Plug Locations for G2332 PC Control Board.

3.Verify that the capacitors have com- pletely discharged with an Analog Volt-Ohm meter.

4.Disconnect leads X2 and X3 from the negative capacitor bank using a 1/2" open end wrench.

See Figure F. 6.

LEADS

X2 AND X3

NEGATIVE

CAPACITOR

BANK

BUSS BAR

FIGURE F.6 - Location of Leads X2

and X3.

5.Separate leads X2 and X3 from the negative capacitor bank buss bar. Be sure there is no electrical con- tact. See Figure F.6.

NOTE: DO NOT DISASSEMBLE THE

SCR RECTIFIER HEAT SINK ASSEM-

BLY.

6.Construct the circuit shown in Figure F.7. One 6-volt lantern battery can be used. R1 and R2 resistor values are ±10%. Set voltmeter scale low, at approximately 0-5 volts or 5-10 volts.

a.Test the voltage level of the bat- tery. Short leads (A) and (C). Close switch SW-1. Battery voltage should be 4.5 volts or higher. If lower, replace the bat- tery.

WIRE-MATIC 250