Lorex LH300 Series APPENDIX E: REPLACING THE HARD DRIVE, EDGE Series DVR, NOTE:, Removing the Hard Drive, To remove the hard drive:, 5. Disconnect the power and data cables

Appendix E: Replacing the Hard Drive

APPENDIX E: REPLACING THE HARD DRIVE

EDGE Series DVR

The system comes with a pre-installed 3.5" SATA hard drive. You can expand the system with a replacement single hard drive up to 2 terabyte (TB).

Make sure that the system is OFF and the power cable has been disconnected before changing the hard drive.

Removing the Hard DriveTo remove the hard drive:1.Remove the screws from the top panel and side panels of the housing.2.Gently slide the cover away from the front panel and lift off.3.With your hand supporting the hard drive, turn

the unit upside down. Remove the four mounting screws from the bottom of the unit. Turn the unit right side up.

4. Gently slide the hard drive toward the front panel and lift out.5. Disconnect the power and data cables.

NOTE: Make sure to keep the two sets of screws (cover, mounting) in a safe place.

Figure 27.1 Remove cover.

Figure 27.2 Support the HDD with your hand and remove mounting screws.

Figure 27.0 Slide cover away from front panel.

Figure 27.3 Carefully remove the HDD from housing.

104