Appendix B: Connecting Motion / Alarm Devices

+

Installing a PTZ (Pan, Tilt, Zoom) Camera on EDGE LH320 series

You can connect RS-485 PTZ cameras (not included) to the PTZ Control Block on the rear panel of

the system (LH320 series only).

Video (BNC)

D+ (TX+)

D- (TX-)

PTZ camera(not included)

To install a PTZ camera:

1.Connect the Transmit Cable to the D+ (TX+) port of the PTZ block on the rear panel.

2.Connect the Receive Cable to the D- (TX-)port of the PTZ block on the rear panel.

3.Connect the video cable to a BNC port (usually channel 1).

4.Connect the power cable from the PTZ camera to a power outlet.

To configure the PTZ Camera’s Baud Rate and DVR ID on the system:

1.From the Main Menu, click . The Camera menu opens.

2.Click RS-485.

3.Beside Baud Rate, adjust the values to match the baudrate of your PTZ camera.

NOTE:IfinstallingmultiplePTZcameras,ensureallthePTZcamerashavethesamebaudrates. This system is capable of configuring a single baudrate only.

4.OPTIONAL: Beside DVR ID select the system’s DVR ID number.

NOTE: DVR ID is used if you have a single PTZ camera that connects to multiple DVR’s. Each DVR is assigned a DVR ID. Configuring the DVR ID allows the system to match itself with the PTZ camera.

To configure PTZ settings:

1.From the Main Menu, click . The Camera menu opens.

2.Click RS-485.

3.Click PTZ Camera Setup.

4.Click on the camera channel the PTZ camera is connected to.

96