Lorex LH300 Series APPENDIX B: CONNECTING MOTION / ALARM DEVICES, Installing a Sensor on the EDGE Series, DVR, Pins, NOTE:, D-SUB, Pins 6, SENSOR, Connect, NO / NC, Connect a

Appendix B: Connecting Motion / Alarm Devices

APPENDIX B: CONNECTING MOTION / ALARM DEVICES

You can enable Motion Detection and Alarm control from the Main Menu. You can also connect additional motion sensor devices to the system (i.e. motion sensors, door/window sensors) with a D-sub 9 connector (not included). Use a motion detector or sensor to send a signal to the system to begin camera viewing and recording on the matching camera channel (when enabled in the Menu).

NOTE: Some soldering is required when using a D-sub 9 connector.

Installing a Sensor on the EDGE Series

To connect an external alarm sensor to the system:

1.Connect a D-SUB 9 connector (not included) to the ALARM I/O port on the rear panel.

2.Connect Alarm-In wires to pins 1~4; connect NC wire to pin 6 connect NO open to pin 7.

3.Connect the ground wire to pin 9.

DVRD-SUB 9 CONNECTOR

(Not Included)

D-SUB 9 CONNECTOR

Pins 1-4: Alarm input terminals receive a signal from a device (i.e. Door or Window Sensor).

Pins 6, 7: NO / NC: Alarm Output Terminals send a signal to another device when an alarm input is detected.

SENSOR

(Not Included)

94