Using the Main Menu

•Response Duration: Select the time (in seconds) for the system to record after a triggered alarm or motion event:

1~255.

NOTE: The Response Duration also applies to the accompanying message and/or buzzer.

•Alarm/Motion Schedule: Click to enable/disable the Alarm/Motion Schedule for each day of the week/ hours 0-23.

• Enabled (yellow) • Disabled (green)

Figure 13.5 Alarm/Motion Schedule (8/16-channel only)

•Select the size of the selection cursor by clicking: 1x1 , 1x13, 3x5, 3x13, 5x9, 7x13

•To save your settings, right-click until you return to the main screen.

Motion

4/8/16-channel

Set the motion detection cells and sensitivity for each camera.To configure motion detection:

1.From the Alarm menu, click Motion Enable. The text, "Motion" will appear on-screen when motion is detected on the respective camera.

2.Choose a camera for motion detection and select O.

3.Click Motion. Select the camera you want to configure motion detection. The motion grid appears for the selected camera.

Figure13.6Selectthecameraformotion detection (4-channel)

4.Click within the grid to enable/disable individual motion cells. Enabled cells are light green; disabled cells are clear.

•Motion Detection Enabled•Motion Detection Disabled

Figure 13.7 Select cells and adjust sensitivity

5.Click the Sensitivity bar at the bottom of the screen. Scroll up/down to increase/ decrease the sensitivity for the motion cells from 0~100. The higher the number, the greater the sensitivity.

NOTE: Sensitivity applies to all cells. If the Sensitivity bar is not visible, click .

6.Click to enable/disable the entire grid.7.To save your settings, right-click until you return to the main screen.

37