Lucent Technologies PA-8500 manual Preparing to Install the System

Installation Guide

1.Preparing to Install the System

●Safety Considerations

●Required Tools

●System Description-- for DNCP Series 400 (PA-8500) Cabinet

●System Description-- for DNCP Series 400-CO (PA-8500) Cabinet

●Status Lights

●System Peripherals

2.Installing the Core System Components

●Installing the Cabinet -- for DNCP Series 400 (PA-8500)

●Installing the Cabinet -- for DNCP Series 400-CO (PA-8500)

●Installing the System Console

●Installing a C419/C619 Modem for RSN Use

●Installing PCI Cards and Cables

3.Installing the Tape Drives

●Installing a Stand-Alone T800-Series Tape Drives

●Installing Daisy-Chained T800-Series Tape Drives

●Completing the Installation of Tape Drives on a Running System

4.Booting the System

5.Configuring the RSN and C416/C619 Modem

●Preparing to Configure the RSN

●Configuring the RSN

●Configuring the C419/C619 Modem

●Completing and Verifying Configuration of the RSN

6.Sending the Installation Report

●Preparing an Installation Report

●Sending an Installation Report to CAC

●Sample Installation Report

Appendix A. Fault Isolation

●General LED Information

●System Component LEDs

❍Power Supply LEDs

❍Disk Shelf LEDs

❍Suitcase LEDs

❍PCI Card LEDs

●System Log and Status Messages

●Component Status

❍Software State Information

❍Hardware Status Information

●Fault Codes

●Troubleshooting Procedures

]