Lucent Technologies PA-8500

p271 Disk Power - - --- - 4

- cab 0 dps 1

p274 Main breaker - - --- - -

- cab 0 mps 0

p274 Main breaker - - --- - -

- cab 0 mps 1

Chapter 6

]

Contents

Main Page Page 1. Preparing to Install the System 2. Installing the Core System Components 3. Installing the Tape Drives 4. Booting the System 5. Configuring the RSN and C416/C619 Modem 6. Sending the Installation Report Preparing to Install the System 1.1 Safety Considerations 1.2 Required Tools 1.3a System Description -- for DNCP Series 400 (PA-8500) 1.3a.1 DNCP Series 400 (PA-8500) Cabinet Page Page 1.3b System Description for DNCP Series 400-CO (PA-8500) Page Page Page 1.4 Status Lights 1.5 System Peripherals Page Chapter 2 Installing the Core System Components 2.1a Installing the Cabinet -- for DNCP Series 400 (PA-8500) 3. Page Page 6. 7. 8. 9. 10. 2.1b Installing the Cabinet For DNCP Series 400-CO (PA-8500) Page Page Page Page 1. 2. 3. 4. 5. 2.2 Installing the System Console Page Page Page 2.3 Installing a C419/C619 Modem for RSN Use Page Page Page Page 2.4 Installing PCI Cards and Cables Chapter 3 Installing Tape Drives Preparing to Install Tape Drives on a Running System Page Page 3. 4. Page Page Page Page Page Page Page 8. 9. Page Chapter 4 Booting the System Page 6. Page Chapter 5 Configuring the RSN and C419/C619 Modem 5.1 Preparing to Configure the RSN 5.2 Configuring the RSN Page Page Page Page Page Page 5.3 Configuring the C419/C619 Modem 5.4 Completing and Verifying Configuration of the RSN Page Page Chapter 6 Sending the Installation Report Page Page Page Page Page Page Page Page Appendix A. Fault Isolation A.1 Component Status LEDs A.1.1.3 Single LEDs A.1.1 General LED information A.1.1.1 Three Color LED Arrangements A.2. System Component LEDs Page A.2.2 Disk Shelf LEDs A.2.2.1 Disk Power Supply LEDs A.2.2.3 SE/LVD Terminator Module A.2.2.4 SES Unit Module A.2.2.5 SE-SE I/O Repeater Module A.2.2.6 Fan Units (3) A.2.3 Suitcase LEDs I A.2.3.1 Suitcase Power-On LED Sequence A.2.4 PCI Card LEDs A.3 System Log and Status Messages A.4 Component Status A.4.1 Software State Information A.4.2 Hardware Status Information ftsmaint sync command can be used to change the device status to Online. A.5 Fault Codes Page A.6 Troubleshooting Procedures