Manuals
/
Brands
/
Marine Equipment
/
Life Jacket
/
Lucent Technologies
/
Marine Equipment
/
Life Jacket
Lucent Technologies
PA-8500
- page 43
1
43
88
88
Download
88 pages, 1.84 Mb
Plug the power cord into the rear of the tape drive and into an AC wall outlet,
See Figure 3.6
.
7.
Figure 3.6. T800-Series Power Cord
Chapter 3
Contents
Main
Page
Page
1. Preparing to Install the System
2. Installing the Core System Components
3. Installing the Tape Drives
4. Booting the System 5. Configuring the RSN and C416/C619 Modem
6. Sending the Installation Report
Preparing to Install the System
1.1 Safety Considerations
1.2 Required Tools
1.3a System Description -- for DNCP Series 400 (PA-8500)
1.3a.1 DNCP Series 400 (PA-8500) Cabinet
Page
Page
1.3b System Description for DNCP Series 400-CO (PA-8500)
Page
Page
Page
1.4 Status Lights
1.5 System Peripherals
Page
Chapter 2
Installing the Core System Components
2.1a Installing the Cabinet -- for DNCP Series 400 (PA-8500)
3.
Page
Page
6.
7.
8.
9.
10.
2.1b Installing the Cabinet For DNCP Series 400-CO (PA-8500)
Page
Page
Page
Page
1.
2.
3.
4.
5.
2.2 Installing the System Console
Page
Page
Page
2.3 Installing a C419/C619 Modem for RSN Use
Page
Page
Page
Page
2.4 Installing PCI Cards and Cables
Chapter 3
Installing Tape Drives
Preparing to Install Tape Drives on a Running System
Page
Page
3.
4.
Page
Page
Page
Page
Page
Page
Page
8.
9.
Page
Chapter 4
Booting the System
Page
6.
Page
Chapter 5
Configuring the RSN and C419/C619 Modem
5.1 Preparing to Configure the RSN
5.2 Configuring the RSN
Page
Page
Page
Page
Page
Page
5.3 Configuring the C419/C619 Modem
5.4 Completing and Verifying Configuration of the RSN
Page
Page
Chapter 6 Sending the Installation Report
Page
Page
Page
Page
Page
Page
Page
Page
Appendix A. Fault Isolation
A.1 Component Status LEDs
A.1.1.3 Single LEDs
A.1.1 General LED information
A.1.1.1 Three Color LED Arrangements
A.2. System Component LEDs
Page
A.2.2 Disk Shelf LEDs
A.2.2.1 Disk Power Supply LEDs A.2.2.3 SE/LVD Terminator Module
A.2.2.4 SES Unit Module
A.2.2.5 SE-SE I/O Repeater Module
A.2.2.6 Fan Units (3)
A.2.3 Suitcase LEDs
I
A.2.3.1 Suitcase Power-On LED Sequence
A.2.4 PCI Card LEDs
A.3 System Log and Status Messages
A.4 Component Status
A.4.1 Software State Information
A.4.2 Hardware Status Information
ftsmaint sync command can be used to change the device status to Online.
A.5 Fault Codes
Page
A.6 Troubleshooting Procedures
