Lucent Technologies PA-8500 manual Powering Up the T800-Series

Chapter 3

8.Turn on the T800-Series power switch, See Figure 3.7. The green power light is illuminated as long as the tape drive is receiving power. If it is not illuminated, check to be sure the cables are securely connected.

Figure 3.7. Powering Up the T800-Series

9.When the system is booted, the tape drive will come online, as described in Chapter 4, "Booting the System."

3.3Installing Daisy-Chained T800-Series Tape Drives

Two T800-series tape drives can be daisy-chained to each U501 SCSI PCI card in the system. To install daisy-chained tape drives, perform the following steps.

This procedure assumes that the system power is off or that the SCSI bus to which the tape drives will be attached has been suspended.

1.Verify that the shipping cartons contain the items included with Daisy- Chained T800-Series Tape Drives, See Items Included with Daisy-ChainedT800-Series Tape Drives .

]