Turn on the power switch on the rear of each tape drive, See Figure 3.14. The green power light on each tape drive
is illuminated and remains lit as long as the tape drive is receiving power. If the light does not illuminate, check to
be sure that the power cables are securely connected.
8.
Figure 3.14. Powering Up the T800-Series (2nd)
To change the SCSI identification on a T800-Series tape drive, first power down the tape drive. The SCSI identification is
read by the system when the tape drive is powered up. If you change the SCSI identification display after power-up, the
new identification will not be registered by the tape drive. Any attempts to access the tape drive will result in an
application error.
If you installed the tape drives on an offline system, the tape drives will come online when you boot the system.
(See Chapter 4 Booting the System.)
9.
3.4 Completing the Installation of Tape Drives on a Running System
Chapter 3
]