Connecting the Digital 8•Bus to ADATs Using an External Sync Box

Cabling and Hookup

1.Connect a fiber optic (lightpipe) cable between the ADAT’s DIGITAL IN and the DIO•8 card’s ADAT OPTICAL OUT. Likewise, connect the DIO•8 cards’ OPTICAL IN to the ADAT’s

DIGITAL OUT.

2.Connect the 9-pin D-sub sync cables between the Sync Box (SYNC OUT) and the first ADAT’s SYNC IN connector. Then connect the sync cables in a daisy-chain fashion between the remaining ADATs. Connect the SYNC OUT on the last ADAT to the SYNC IN on the Sync Box to complete the loop.

3.Connect MIDI cables between the MIDI OUT connector on the Digital 8•Bus’ Remote CPU and the MIDI IN connector on the Sync Box, and between the MIDI IN connector on the Digital 8•Bus’ Remote CPU and the MIDI OUT connector on the Sync Box.

Settings

D8B

1.Open the Setup window by pressing Ctrl+1 or clicking Setup in the bottom menu bar on-screen.

4.Set the “Samplerate” to match the sample rate of the formatted ADAT tapes (typically 48 kHz or 44.1 kHz).

ADATs

1. Select DIGITAL IN on the ADAT front panel.

Modular Digital Multitrack

 

 

 

 

 

CLOCK

 

 

 

 

 

 

EXT

 

 

 

 

 

 

48K

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INPUT MON

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INPUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DIGITAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INPUT SELECT

 

INPUT MONITOR

DIGITAL

TRACK

ALL

AUTO

 

INPUT

COPY

INPUT

INPUT

2.Click “Digital I/O” to open the Digital I/O dialog box.

3.Click each Tape Input and Output box and select ADAT for each DIO•8 card installed.

Notes:

•When powering up, turn the Digital 8•Bus on first, then turn the ADATs on.

D8B Manual • Chapter 4 • page 128