9.2.13. Setting the Display Unit
1.Connect the Cables to the connectors (CN2, CN6) of the Main PCB.
2.Put the two Cables into the Clamper.
3.Connect the Inverter Cable to the connector (CN6) of the Power PCB as closing the Rear Cabinet.
4.Attach both the Inverter Case and the Inverter.
5.Hook the Cable on the lamp Cable Spring.
6.Attach the Cable Hold Sheet.
7.Set the LCD Unit with its face down and then close the Rear Cabinet.
Main P.C.B. | Connector | |
(CN2) | ||
|
Connector
(CN6)Clamper
Display
Unit
Lamp Cable Spring | Rear Cabinet |
Cable Holder Sheet | Connector(CN6) |
Cable
Inverter | IO Power P.C.B. |
