Micron Technology Transport LT Using the Battery, Installing a Hard Drive, Charging the Battery

Introducing Your TransPort LT Using the Battery

5. Pull the hard drive out of the computer.

CAUTION:	Only install a hard drive that is thinner than 9.5 mm in this computer.
Installing a Hard Drive	To install a hard drive:
	1. Remove the old hard drive from the computer as described in the previous
	section.
	2. Slide the new drive into the hard drive compartment. Make sure the drive is
	pushed back as far as it will go.
	3. Install the screw that holds the hard drive in place.
	4. If you intend to use save-to-disk mode, see “Creating a Save-To-Disk Partition”
	on page 97.
	5. Format your drive and reinstall your files. See ”MCRC (Micron Customer
	Resource Center)” on page 99 for instructions on re-installing the Operating
	System and drivers for your Transport LT notebook computer.
Using the Battery	Your computer uses a smart rechargeable Lithium-ion (Li-ion) battery pack for
	power when the AC adapter is not attached to an electrical outlet. The smart
	battery gives an accurate measurement of the current battery capacity which
	helps extend operating time by enabling effective power management in
	Operating Systems that take advantage of the accurate information supplied by
	the battery.
Charging the Battery	Your computer’s battery starts charging automatically when you connect the
	power to the computer and to an electrical outlet. If the computer is off, the battery
	charges faster than if the computer’s power is on.
	Approximate charging times for Li-Ion (Ni-MH) battery are:
	• Two and a half (2.5) hours with the computer off.
	• Four (4) hours with the computer on.
	While the battery is charging normally, the battery charge light on the computer is
	amber (See ”System Status Lights” on page 29 for the location of the battery
	charge light). When the battery is fully charged, the light changes to green.

41