Micron Technology Transport LT warranty Battery Warnings, Doesn’t dee, Condition Action to Take

Introducing Your TransPort LT Using the Battery

To set battery monitoring options in PowerProfiler:

1.Double-click the PowerProfiler battery icon to open the software.

2.Click the Battery tab.

3.Set options under Battery Status and Alarm Settings.

For more information on PowerProfiler, see the Help option in the PowerProfiler software.

Battery Warnings	Your computer gives you the following low-battery warnings (Table 5).
	TABLE 5. Battery Warnings
		Warnings	Condition	Action to Take
		The computer beeps 5	Battery low: The battery	Save your work. Use the
		times.	charge is about 10	power cord to power the
			percent. Approximately	computer or turn off the
			5–10 minutes of battery	computer and install a fully
			charge is left.	charged battery.
		The computer beeps 5	Battery very low: The	Use the power cord to
		times, with a short time	battery charge is about 5	power the computer and
		between beeps. After a	percent.	charge the battery.
		short time, the computer

automatically goes into	doesn’t dee.
rest mode.

The above features are valid with Windows 95/98 APM compliant Operating Systems. In the case of a Windows 98 or any other ACPI compliant Operating System which is running on APM interface, you should adjust the battery alarm features by using the Operating Systems power management program (Control Panel > Power management in Windows 98).

Windows 98 and WIndows 2000 can operate in APM or ACPI mode, in the APM mode you should select the Rest mode of the low battery situations (Power On Suspend/Save-to-Disk) in BIOS setup. See “Power Menu” on page 84.

If you cannot run your computer from the battery and the battery will not charge when you attach the power cord, the problem may be that:

45