Introducing Your TransPort LT

Installing the Modem Driver in Windows 95/98

 

Command Mode

 

If you turn on your computer and start communication by a communication

 

program, you can see a prompt on the terminal screen. Under such conditions,

 

you can use AT commands like calling, etc.

 

DATA Mode

 

In command mode, you can call by using AT commands and communicate with

 

others by connecting to other modems. You can call this status Data mode or On-

 

line mode. In data mode, you cannot use any AT commands except the +++

 

command, which has +++ at the head.

 

If you stop communication and disconnect the phone, the Fax modem will run in

 

command mode again.

 

Using Command Mode during Communications

 

Sometimes, you have to use AT commands while you're communicating with

 

others via modem. In this case, you can use +++ commands for AT commands

 

without hanging up your telephone. Pressing '+' three times makes fax modem

 

change to command mode. The telephone will not be disconnected. (Do not press

 

the [Enter] key after input +++).

CAUTION:

If you want to return to Data Mode, the connection may be lost depending

 

on the server.

 

If you want return to Data mode from command mode, you only have to input ATO

 

and press the [Enter] key to start the communications again.

CAUTION:

The mode cannot be transferred from the command mode to the data mode

 

depending on the server.

Using AT commands

AT commands can be used in the following way. There's no difference between

 

capital letters and small letters, and all commands should include 'AT' as a prefix

 

except ones which include 'A/' instead.

 

Also, Carriage Returns saved in the S3 register should be entered in order to

 

signal the end of the command.

 

AT command - press the [Enter] key.

 

Example: ATDT 123-4567 - press [Enter] and the modem dials to 123-4567.

50

Page 50
Image 50
Micron Technology Transport LT warranty Using AT commands, On the server, Depending on the server