Parameter description:
These trap functions are as they describe. The special one is Module Swap. It means that when the switch detects a module with the different module ID to be inserted, the switch treats it as Module swapped. The traps that the switch supports are listed below.
ySTP: STP Topology Change, STP Disabled, STP Enabled
yLACP: LACP Disabled, LACP Enabled, LACP Member Added, LACP Port Failure
yGVRP: GVRP Disabled, GVRP Enabled
yVLAN: VLAN Disabled,
yModule Swap: SEP Inserted, SEP Removed,
yTrap: Cold Start, Warm Start, Link Down, Link Up, Authentication Failure, User login, User logout
3.15.2Email/SMS
Alarm configuration is used to configure the persons who should receive the alarm message via either email or SMS, or both. It depends on your settings. An email address or a mobile phone number has to be set in the web page of alarm configuration. Then, user can read the trap information from the email or the mobile phone. This function provides 6 email addresses and 6 mobile phone numbers at most. The 24 different trap events will be sent out to SNMP Manager when trap event occurs. After ticking trap events, you can fill in your desired email addresses and mobile phone numbers. Then, please click <Apply> button to complete the alarm configuration. It will take effect in a few seconds.
Note: SMS may not work in your mobile phone system. It is customized for different systems.
Parameter description:
yEmail:
yMail Server: the IP address of the server transferring your email.
51
