yEdit Administrative Control:

VLAN identifier. When GVRP group creates, each dynamic VLAN group owns its VID. Valid range is 1 ~ 4094.

yMember Port:

Those are the members belonging to the same dynamic VLAN group.

yEdit Administrative Control:

When you create GVRP group, you can use Administrative Control function to change Applicant Mode and Registrar Mode of GVRP group member.

yRefresh:

Refresh function can help you to see current GVRP group status.

3.12 STP

The Spanning Tree Protocol (STP) is a standardized method (IEEE 802.1D) for avoiding loops in switched networks. When STP is enabled, ensure that only one path is active between any two nodes on the network at a time. User can enable Spanning Tree Protocol on switch’s web management and then set up other advanced items. We recommend that you enable STP on all switches to ensure a single active path on the network.

3.12.1Status

In the Spanning Tree Status, user can read 12 parameters to know STP current status. The 12 parameters’ description is listed in the following table.

Parameter description:

ySTP State:

Show the current STP Enabled / Disabled status. Default is “Disabled”.

yBridge ID:

Show switch’s bridge ID which stands for the MAC address of this switch.

yBridge Priority:

Show this switch’s current bridge priority setting. Default is 32768.

yDesignated Root:

Show root bridge ID of this network segment. If this switch is a root bridge, the “Designated Root” will show this switch’s bridge ID.

yDesignated Priority:

36

Page 37
Image 37
MicroNet Technology SP1659P 3.12 STP, Status, y Edit Administrative Control, y Refresh, y STP State, y Bridge ID