Mitel 3300 ICP manual Tag Call, Trunk Flash

1.Press (SUPERKEY).

2.Press the No softkey until "Timed Reminder?" appears.

3.Press the Yes softkey.

4.Do one of the following:

•To change the Reminder, press the Change softkey, enter the new time, and press the Save softkey.

•To cancel the Reminder, press the Clear softkey.

•To exit without canceling the Reminder, press (SUPERKEY).

To acknowledge a Reminder when your phone rings once:

•Press the Confirm softkey.

Tag Call

Tag Call allows you to signal that you are the victim of a threatening or malicious call. Using the tag, your system administrator or telephone company can identify the source of the call and provide this information to appropriate personnel or authorities.

CAUTION: Tagging a non-malicious call may result in fines or other penalties.

To tag a malicious call, do one of the following:

•Press the Tag Call feature key while the call is in progress.

See Personal Feature Keys on page 31 for instructions on programming a Tag Call key to your phone.

•Press (TRANS/CONF), then dial *55.

If the call was successfully tagged, the display shows "Thank You"; otherwise, the display shows "Not Allowed".

Note: Tag Call can be used on active two-party calls only. Calls on hold and conference calls cannot be tagged.

Trunk Flash

The Trunk Flash feature allows you to access Centrex features (if available) while you are talking on an outside call.

To flash a trunk while talking on an outside call:

1.Press (TRANS/CONF).

2.Dial *57 for a single flash or *56 for a double flash.

3.Wait for dial tone.

4.Dial the Centrex feature access code.

56