Installing the Equipment | Installing the MR-J3-D01 Extension |
| |
2 Installing the Equipment
The procedure for the physical installation of the MR-J3-T series hardware is exactly the same as for the MR-J3-A and MR-J3-B models. The dimensions of the MR-J3-T series amplifiers are identical to those of the matching models of the MR-J3-A and MR-J3-B series.
| | NOTE | | | | Please consult the instruction manual for detailed installation instructions. |
| | | |
2.1Installing the MR-J3-D01 Extension
Procedure:Remove the cover of the CN7 connector on the right side of the MR-J3-T housing.
Upper mounting | Upper mounting |
point 2 | point 1 |
Cover for CN7 connector
Lower mounting | Lower mounting |
point 2 | point 1 |
Fig. 2-1:Fixing points of the extension MR-J3-D01
Position the MR-J3-D01 extension over the upper and lower mounting points 1 on the ser- vo amplifier, then press the extension into place so that the lugs click into position in the up- per and lower mounting points 2. This also connects the extension to the amplifier via con- nector CN7 on the amplifier.
Fasten the extension securely to the servo amplifier with the M4 screw (included) as shown in Fig. 2-2.