Edit NetCommand®: Add an A/V Receiver, continued
A/V Receiver (AVR) Input Learn Screen
Figure 10
NetCommand can now learn the remote control signals used to select each input on the A/V receiver.
1.Press ADJUST 
or 
on the TV remote to select the check box for each function to be learned.
2.Press ENTER and the function name will begin to flash to confirm the
3.Press the button on the A/V receiver’s remote control that corresponds to the selected function. A check mark will appear and the function name will stop flashing. This confirms the signal learned status.
4.To test the learned command, press ENTER on the TV remote. The A/V receiver will perform the selected function. The A/V receiver needs to be turned on and the IR emitters properly placed for the test to be successful (see page 32 for IR emitter placement).
5.To customize the input names, press ADJUST 
to move to the Input Name text box and then press ADJUST 
or 
and ENTER to select each letter of the name. These names will appear on the Review screen as the A/V receiver’s input names, and should match the names the A/V receiver shows in its own display.
6.To erase the learned input signal, highlight the check box for that input and press CANCEL.
7.Repeat for each connected input.
8.When the input selection signals have been learned and the inputs named, press ADJUST 
to select Next> and move to the A/V receiver Learn screen.
A/V Receiver (AVR) Learn Screen
Figure 11
1.Press ADJUST 
or 
on the TV remote to select the check box for each function to be learned.
2.Press ENTER and the function name will begin to flash to confirm the
3.Press the button on the A/V receiver’s remote control that corresponds to the selected function, A check mark will appear and the function name will stop flashing. This confirms the signal learned status.
4.To test the learned command, press ENTER on the TV remote. The A/V receiver will perform the selected function. The A/V receiver needs to be turned on and the IR emitters properly placed for the test to be successful (see page 32 for IR emitter placement).
5.Repeat for each function to be learned.
6.To erase a learned function, highlight the check box for that function and press CANCEL.
7.When the function signals have been learned, press ADJUST 
to select Next> and move to the Name screen.
Figure 10. A/V receiver Input Learn screen
Figure 11. A/V receiver Learn screen
IMPORTANT
When learning remote control signals, point the device’s remote at the TV screen
46Chapter 3. NetCommand Setup and Editing
