Mitsubishi Electronics WD-73727 Antenna with a Single Lead, For antennas with flat twin leads

Connecting an Antenna with a Single Lead or Antennas with Separate UHF and VHF Leads

Antenna with a Single Lead

(not for use with CableCARD™)

Figure 3

For antennas with flat twin leads

A300-ohm-to-75-ohm transformer is required. This is not included with the TV, but is available at most electronics stores.

1.For an antenna with flat twin leads, connect the

300-ohm twin leads to the 300-ohm-to-75-ohm transformer.

2.Push the 75-ohm side of the transformer onto ANT-1 MAIN on the TV back panel.

For cable or antenna with coaxial lead

Connect the coaxial lead directly to ANT-1 MAIN on the TV back panel.

		57 CBDL QBOFM TFDUJPO
0IN	0IN
'MBU5XJO	$PBYJBM
-FBE	$BCMF
		
0QUJPOBM 0INUP0IN
.BUDIJOH 5SBOTGPSNFS

Figure 3. Connecting a Single Antenna

Antennas with Separate UHF and VHF Leads

Figure 4

A UHF/VHF combiner is required. This is not included with the TV, but is available at most electronics stores.

1.Connect the UHF and VHF antenna leads to the UHF/ VHF combiner.

2.Push the combiner onto ANT-1 MAIN on the TV back panel.

7)' "OUFOOB	6)' "OUFOOB
$IBOOFMT 	$IBOOFMT 
'MBU 5XJO -FBE		'MBU 5XJO -FBE
&YUFSOBM			57 CBDL QBOFM TFDUJPO
"OUFOOB
PS $BCMF
	 0IN UP
	 0IN
	$PNCJOFS		
	6)'
	7)'
	#BDL	4JEF
	7JFX	7JFX
		4OO!.4!-!).

Figure 4. Connecting separate UHF and VHF Antennas

Mitsubishi strongly recommends you avoid using antennas with flat twin leads. Flat twin lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

Chapter 2. Connecting 25