DCT3080 Installation Manual
Code | Description | When Error Occurs | Action Required |
| Platform ID | OOB frequencies (LED then | operator |
| found | displays Eb 02, indicating |
|
|
| the software object download |
|
|
| was unsuccessful.) |
|
Eb18 | Object size | After the LED displays dl, | Contact headend |
| mismatch | indicating failed during | operator |
|
| attempted download |
|
Eb19 | Object size | After the LED displays dl, | Contact headend |
| failed range | indicating failed during | operator |
| check | attempted download |
|
Eb20 | Invalid SUDB | After plugging the terminal | None |
| pointer | into an electrical outlet to |
|
|
| begin the boot cycle |
|
Operational Check for the Remote Control
The operational check tests communication with the remote control:
Table
Operational check procedures
Feature | Testing Procedure |
Power on | Press POWER on the remote control to turn on the DCT3080. |
| Tune to the output channel (3 or 4). |
Channel | Scan through the channels using the CHANNEL + or - keys. |
selection |
|
| Tune to several channels by entering the channel number using |
| the numeric keys. |
Volume | Press VOLUME + or - on the remote control to increase the |
control | volume to its upper limit, lowest level, and to a comfortable |
| level. |
| Press MUTE to turn the sound off. Press MUTE again to restore |
| the sound. |
If the DCT3080 does not operate properly, refer to Section 5, “Troubleshooting.”
36
