Motorola SVG1501UE Field, Description, Name, Enable drop-down, Local Endpoint Settings, Identity

B

Field	Description
Name	Assign a generic name for a group of settings to a single
	tunnel.
	After entering the appropriate tunnel name for the first time,
	click Add New Tunnel to create a heading for the tunnel
	settings selected from the Tunnel drop-down list. If you do not
	assign a name, the tunnels are sequentially numbered.
Enable drop-down	After you name and configure a VPN tunnel, you can store it as
	disabled or enabled via the Enable/Disable drop-down list.
	Click Apply to toggle Enable/Disable.
Local Endpoint Settings	Set the local VPN access group as one of the following group
Address group type	types:
	Single IP address — for one computer, enter the IP address
	for the specific computer
	IP address range — for a small range of computers, enter the
	starting and ending IP addresses for the group of consecutive
	IP address that will have access to the VPN tunnel
	IP Subnet — for an entire subnet/network, enter the Subnet
	and Mask for IP address range and IP Subnet. Enter the
	starting and ending IP addresses for the group of consecutive
	IP addresses that are to have access to the VPN tunnel.
Identity Type	Define the local endpoint identity type to automatically use the
	WAN IP address of the router or as a user-specified IP address,
	fully qualified domain name (FQDN), or e-mail address. The far
	endpoint uses this to identify the VPN termination point and
	handshake.
	The remote VPN endpoint on the other side of the tunnel
	should match these settings for its remote endpoint settings.
Identity	Enter the identity string.
	For IP address, enter x.x.x.x.
	For FQDN, enter yourdomain.com
	For email address identity, enter yourname@yourdomain.com
	The remote VPN endpoint on the other side of the tunnel
	should match these settings for its remote endpoint settings.

10 • VPN Pages 60