Motorola SVG1501UE, SVG1501E manual Connecting the SVG1501

B

Connecting the SVG1501

CAUTION: To reduce the risk of fire, use only No. 26 or larger UL Listed or CSA Certified Telecommunication Line Cord or national equivalent to connect a telephone line to your SVG1501.

Contact your service provider before connecting your Motorola SVG1501 to your existing telephone wiring. Do not connect the telephone wire to a traditional telephone (PSTN) service.

Before starting, be sure the computer is turned on and the SVG1501 power cord is unplugged.

1.Connect the coaxial cable to the cable outlet or splitter, and then to the Cable connector on the SVG1501.

Hand-tighten the connectors to avoid damaging them.

2.Plug the power cord into the Power port on the SVG1501 and then into an electrical wall outlet.

This automatically powers on the gateway. You do not need to unplug the gateway when it is not in use. The first time you plug in the SVG1501, allow 5- to 30 minutes to find and lock on the appropriate communications channels.

3.Connect the Ethernet cable to the Ethernet port on the computer and then to the Ethernet port on the gateway.

4.Plug the telephone cord of a single or two-line telephone into the telephone and then into the TEL 1/2 port on the rear of the SVG1501.

Note: Contact a VoIP service provider to activate this service.

5.For a second telephone, plug the telephone wire of a single-line telephone into the TEL 2 port on the rear of the SVG1501.

6.Check that the LEDs on the front panel cycle through the following sequence:

2 • Getting Started 10