Moxa Technologies 5400 Series user manual Telnet Console

NPort 5400 Series User’s Manual Initial IP Address Configuration

Take the following steps to use ARP to configure the IP address:

1.Obtain a valid IP address for your NPort from your network administrator.

2.Obtain the NPort’s MAC address from the label on its bottom panel.

3.Execute the ‘arp -s’ command from your computer’s MS-DOS prompt by typing: arp –s 192.168.200.100 00-90-E8-xx-xx-xx

This is where 192.168.200.100 is the new IP address and 00-90-E8-xx-xx-xx is the MAC address for your NPort. You will need to change both numbers, as described above in points 1 and 2.

4.Next, execute a special Telnet command by typing: telnet 192.168.200.100 6000

After issuing this command, a Connect failed message will appear, as shown here. After the NPort reboots, its IP address should be updated to the new address, and you can reconnect using either Telnet, Web, or Administrator to check that the update was successful.

Telnet Console

Depending on how your computer and network are configured, you may find it convenient to use network access to set up your NPort’s IP address. This can be done using the Telnet program.

1.From the Windows desktop, click on Start and then select Run.

2.Type telnet 192.168.127.254 (use the correct IP address if different from the default) in the Open text input box, and then click OK.

3.When the Telnet window opens, if you are prompted to input the Console password, input the password and then press Enter.

Note that this page will only appear if the NPort is password protected.

3-6