Review and Apply Settings | Moxa Technologies MOXA AirWorks specification

MOXA AirWorks AWK-1100 User’s Manual

Getting Started

Step 6: Configure AWK-1100’s IEEE 802.11 settings

Go to the IEEE 802.11 Communication section to configure IEEE 802.11g-related communication settings, including Regulatory domain, Channel number, and Network name (SSID).

The number of available RF channels depends on local regulations; therefore, you will need to choose an appropriate regulatory domain to comply with local regulations. The SSID of a wireless client computer and the SSID of the AWK-1100 must be identical for them to be able to communicate with each other.

When you are finished, click on Save at the bottom of the page. This will return you to the home page.

Step 7: Review and Apply Settings

On the home page, you can review all of the settings you have made. Changes are highlighted in red. If the changes are okay, click on Restart to restart the AWK-1100 for the new settings to take effect.

2-4

Image 12

Moxa Technologies MOXA AirWorks user manual Configure AWK-1100’s Ieee 802.11 settings, Review and Apply Settings

Contents

Moxa AirWorks AWK-1100 User’s Manual First Edition, July Copyright Notice TrademarksDisclaimer Table of Contents Page Introduction Package Checklist Product FeaturesProduct Specifications Overview Mechanical Page ‰ Confirming the Settings of the AP and Client Computers Getting Started First-Time Installation and Configuration Select the Operational Mode for AWK-1100 AP/BridgeAP Client Configure AWK-1100’s Ieee 802.11 settings Review and Apply Settings Deploying the Access Point AP Setting up Client ComputersConfiguring Ieee 802.11g-related Settings Confirming the Settings of the AP and Client Computers Configuring TCP/IP-related SettingsChecking if the Ieee 802.11g-related Settings Work Checking if the TCP/IP-related Settings Work To check if a client computer can assess the InternetPage Web Console Configuration ‰ Viewing Status Menu Structure Save, Save & Restart, and Cancel Buttons Home and Refresh Buttons Associated Wireless Clients Viewing StatusCurrent Dhcp Mappings System Log Link Monitor AP Client mode only Specifying the Operational ModeGeneral Operations STA-AP Administrative Password Managing the FirmwareUpgrading Firmware by Http AP/Bridge AP Client Backing up and Restoring Configuration Settings by Http Upgrading Firmware by Tftp Choose Tftp as the Firmware management protocol Backing up and Restoring Configuration Settings by Tftp Configuring TCP/IP-related Settings Resetting the Configuration to Factory DefaultsAddressing Dhcp Server AP/Bridge modes only BasicStatic Dhcp Mappings Configuring Ieee 802.11g-related Settings CommunicationLink Integrity Wireless Distribution System Association ControlAP Load Balancing Sample wireless bridge network topology Security STA Shared Key , and Auto MAC-Address-Based Access Control Set the Access control type to exclusiveSet the Access control type to inclusive Ieee 802.1X/RADIUS AP mode only Click Download Internet Configuring Advanced Settings Packet FiltersEthernet Type Filters IP Protocol Filters Management TCP/UDP Port FiltersUPnP System Log Snmp Page Default Settings LAN Interface ManagementSnmp read community Snmp write community Troubleshooting Wireless Settings ProblemsWireless client computer cannot associate with an AWK-1100 TCP/IP Settings Problems AP does not respond to ping from the client computer Unknown Problems Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement Federal Communication Commission Interference StatementTTE Compliance Statement Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement Service Information Moxa Internet Services Following services are provided Problem Report Form Moxa Product † AWK-1100-US † AWK-1100-EU Serial Number Product Return Procedure