Sta | Moxa Technologies MOXA AirWorks, AWK-1100 specification

MOXA AirWorks AWK-1100 User’s Manual

Web Console Configuration

STA 1

AP 1

WCI:

This AP Only

STA 2

Switch

STA 3

AP 2

WCI:

This AP Only

Wireless Link

Ethernet Link

Behavior of the “This AP Only” wireless client isolation option

STA 1

STA 2

STA 3

AP 1

WCI:

All APs in This

Subnet

Switch

AP 2

WCI:

All APs in This

Subnet

Wireless Link

Ethernet Link

Behavior of the “All APs on This Subnet” wireless client isolation option

When AP 1 and AP 2 are using the “This AP Only” option, wireless traffic between STA 1 and STA 2 is blocked by AP 1, whereas wireless traffic between STA 2 and STA 3 (which are associated with different APs) is still allowed. If the “All APs in This Subnet” option is used as shown in above figure, AP 1 and AP 2 communicate with each other via an inter-AP protocol to share their STA association information to block wireless traffic among all the STAs.

3-16

Image 32

Moxa Technologies MOXA AirWorks, AWK-1100 user manual Sta

Contents

Moxa AirWorks AWK-1100 User’s Manual First Edition, July Disclaimer Copyright NoticeTrademarks Table of Contents Page Introduction Package Checklist Product FeaturesProduct Specifications Overview Mechanical Page ‰ Confirming the Settings of the AP and Client Computers Getting Started First-Time Installation and Configuration AP Client Select the Operational Mode for AWK-1100AP/Bridge Configure AWK-1100’s Ieee 802.11 settings Review and Apply Settings Configuring Ieee 802.11g-related Settings Deploying the Access Point APSetting up Client Computers Checking if the Ieee 802.11g-related Settings Work Confirming the Settings of the AP and Client ComputersConfiguring TCP/IP-related Settings Checking if the TCP/IP-related Settings Work To check if a client computer can assess the InternetPage Web Console Configuration ‰ Viewing Status Menu Structure Save, Save & Restart, and Cancel Buttons Home and Refresh Buttons Associated Wireless Clients Viewing StatusCurrent Dhcp Mappings System Log Link Monitor AP Client mode only Specifying the Operational ModeGeneral Operations STA-AP Administrative Password Managing the FirmwareUpgrading Firmware by Http AP/Bridge AP Client Backing up and Restoring Configuration Settings by Http Upgrading Firmware by Tftp Choose Tftp as the Firmware management protocol Backing up and Restoring Configuration Settings by Tftp Addressing Configuring TCP/IP-related SettingsResetting the Configuration to Factory Defaults Static Dhcp Mappings Dhcp Server AP/Bridge modes onlyBasic Link Integrity Configuring Ieee 802.11g-related SettingsCommunication AP Load Balancing Wireless Distribution SystemAssociation Control Sample wireless bridge network topology Security STA Shared Key , and Auto Set the Access control type to inclusive MAC-Address-Based Access ControlSet the Access control type to exclusive Ieee 802.1X/RADIUS AP mode only Click Download Internet Configuring Advanced Settings Packet FiltersEthernet Type Filters IP Protocol Filters Management TCP/UDP Port FiltersUPnP System Log Snmp Page Default Settings LAN Interface ManagementSnmp read community Snmp write community Wireless client computer cannot associate with an AWK-1100 TroubleshootingWireless Settings Problems TCP/IP Settings Problems AP does not respond to ping from the client computer Unknown Problems Moxa AirWorks AWK-1100 User’s Manual TTE Compliance Statement Regulatory StatementFederal Communication Commission Interference Statement Moxa AirWorks AWK-1100 User’s Manual Regulatory Statement Service Information Moxa Internet Services Following services are provided Problem Report Form Moxa Product † AWK-1100-US † AWK-1100-EU Serial Number Product Return Procedure