4.1Introduction
This chapter covers the loading of the software utility and then the configuration of the unit from either a Windows based pc or a dumb terminal. When a Windows based pc is used, the software utility is loaded using the procedures in section 4.2 and then the unit is config- ured using the procedures in section 4.3. If a dumb terminal is used, the MulitFRAD 100 can be configured using the ASCII terminal menu system present in memory of the unit.
4.2Loading Software
1Turn on your PC connected to the Data Port of your MultiFRAD and run Windows®.
2Create a backup copy of your MultiFRAD software diskette before you install the software. Store the master diskette in a safe place and install the MultiFRAD software using the backup copy.
3Insert the backup disk for the MultiFRAD into the floppy drive.
4Click on the File Menu in your Program Manager.
5Click on Run. The Run dialog box is displayed.
6Type a:\install or b:\install (depending on the location of your floppy disk drive) in the Command Line field, and then click on OK.
7The MultiFRAD 100 - Select Directories dialog box is displayed.
If you are installing the software from drive A and your Destina- tion Directory is the default directory, click on OK to continue
8 The Installing MultiFRAD dialog box is displayed.
37
