Multi-Tech Systems MVPFXS-24, MVPFXS-8, MVPFXS-16 manual Identify Remote Voip Site to Call

Preliminaries & Info GatheringMultiVOIP FXS Quick Start Guide

Config Info CheckList

Type of Config Info	MultiVOIP
Gathered	Configuration screen
	on which to enter Config
	Info
		√
IP info for voip unit	IP Parameters
● IP address
● Gateway
● DNS IP (if used)
Interface Type	Interface Parameters
(FXS only*)	*In FXO/FXS systems, channels used
	for phone, fax, or key system are
	FXS; channels used for analog PBX
	extensions or analog telco lines are
	FXO.
Country Code	Regional Parameters
Network Locations of SIP Proxy	SIP Call Signaling
units, if used
(IP Address or Domain Name)

Reminder: Be sure to Save & Apply after entering configuration values.

Identify Remote VOIP Site to Call

When you’re done installing the MultiVOIP, you’ll want to confirm that it is configured and operating properly. To do so, it’s good to have another voip that you can call for testing purposes. You’ll want to confirm end-to-end connectivity. You’ll need IP and telephone information about that remote site.

If this is the very first voip in the system, you’ll want to coordinate the installation of this MultiVOIP with an installation of another unit at a remote site.

16