Muratec M840, M880, M860 Automatic redial, Redialing manually, Canceling automatic redial

Getting Started

Redialing

Automatic redial

If the call fails, your fax machine will automatically attempt to redial the number if you tried to transmit using a one-touch key, a speed-dial number, or a number entered on the numeric keypad.

The fax machine will wait 3 minutes before automatically redialing.

If unsuccessful, it will attempt a total of 6 automatic redials at 3 minutes interval.

Note: If you used either on-hook dialing or a handset, redial manually.

Redialing manually

You always can redial fax or voice calls manually; and, again, you must redial manually if you dialed by using either on-hook dialing or a handset.

To redial a fax call manually without using on-hook dialing or a handset:

1.Confirm that the document is still in the feeder and that your desired resolution and contrast settings are still correct.

2.Press redial/pause, then start.

To redial a fax call manually by using on-hook dialing or a handset:

1.Confirm that the document is still in the feeder and that your desired resolution and contrast settings are still correct.

2.Obtain a dial tone: either press monitor/call or lift the handset.

3.Press redial/pause.

4.When you hear fax tones from the remote fax unit, press start.

Note: If a person answers the phone, tell him or her you’re trying to send a fax. When his/her fax machine sends you fax tones, press start.

To redial a voice call manually:

1.Obtain a dial tone: either press monitor/call or lift the handset.

2.Press redial/pause. When the other person answers, speak to him/her on the handset.

Canceling automatic redial

To cancel an automatic redial, press stop. or

You’ll use the Review Command function.

If you wish to review or cancel the command, here’s how:

1.Press program, 5.

Review Command

2.Press mode/enter.

COM1 : 123-4567

In the example above, the fax machine is holding a command for a delayed transmission to phone number 123-4567. Also, if a “right-now” transmission attempt to the same number has been blocked by a busy signal, you’ll see the above one.

3. When you wish to erase the command, press contrast/cancel.

COM1 : Erased

If you decide not to cancel the command, press stop.

For more information on the Review Command function, please see page 2.10.

1.17