NAD S170iAV owner manual Adjusting The Tone Controls, Using Presets, USING THE S170i, Note That

USING THE S170i

ADJUSTING THE TONE CONTROLS

Press the [ Tone] key; "Treble" appears on the OSD and the front-panel readout. Use the remote's [Cursor Left/Right] to boost or cut treble by 1 dB increments. Press [ Tone] again to adjust bass, similarly using the [Cursor Left/Right] keys; "Bass" appears on the OSD and readout. Press [ Tone] again to exit the tone- control function.

FRONT PANEL TONE BUTTON: Press to toggle between Bass, Treble, and TONE ON. The VOLUME knob is used to adjust the Bass and Treble levels.

NOTE THAT:

•Bass/treble settings affect only the front channels (left, center, and right), and are active in all listening modes

•Bass/treble settings imposed via the HTR 2 remote's [ Tone] will override those stored on the <Audio setup> menu, but they are temporary: Cycling through the S170i's Standby mode (or recalling the <Audio setup> menu), or recalling a Preset, will override them and revert to the settings selected by <Audio setup> or the recalled Preset.

USING PRESETS

From the HTR 2 select [AV Preset]; then press the [ 1] through [ 5] numerical key to select the desired

Preset.

NOTE THAT:

•The selected Preset remains in force until you select a different Preset, or cycle the S170i through its Standby mode.

•A Preset applies regardless of what source is selected, or what listening mode is in operation.

•Cycling the S170i through its Standby mode cancels any selected Preset, reverting both tone and all level settings to those set on the HTR 2 remote’s LEVELS or MODE/MULTI.S screens, or the S170i preamp’s <Audio setup> OSD menu (above).

•A Preset’s channel levels are added to the setup levels established on the S170i preamp’s <Levels setup> OSD menu; a Preset’s tone-control settings override those established on the <Audio setup> OSD menu (or the MODE/MULTI.S remote page) entirely.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL DEUTSCH FRANÇAIS ENGLISH

27