NAD S170iAV Learning Codes from Other Remotes, Cancel Operation, Library Mode, Digit Keys

ENGLISH FRANÇAIS DEUTSCH ESPAÑOL ITALIANO PORTUGUÊS SVENSKA

USING THE HTR 2 REMOTE CONTROL

LEARNING CODES FROM OTHER REMOTES

Begin by positioning the HTR 2 “nose-to-nose” with the source remote so the two devices’ infrared windows are about 2 inches apart.

•Enter Learning Mode: On the HTR 2, simultaneously press-and-hold for 3 seconds both a Device

Selector key and the “record” key (just below the [DISP] key), until the Learn LED at the centre of the HTR 2 turns steady green.

•Press the HTR 2’s Control key you wish to teach a command; the Learn LED will turn amber.

•Press-and-hold the control function key on the source remote: The HTR 2’s Learn LED will flicker amber for a second or two, then turn solid green. The command is learned. Repeat this process for all commands you wish to learn under the selected Device Selector key.

•Press the HTR 2’s Device Selector key again to exit the learning mode after you have completed learning all commands for that Device.

NOTE

If the Learn LED does not flicker amber you may need to vary the distance between the remotes or try fresh batteries in both remotes. If the Learn LED turns red rather than green, that particular command of that source remote command has not been learned. Try again. In rare instances there may be some IR format that is not compatible with the HTR 2.

CANCEL OPERATION

You can cancel configuring a key, by pressing the active Device Selector key beofre the learn is complete; the Learn LED will turn red.

Example: Learning “DVD Pause”:

Position the HTR 2 and your DVD player’s remote as described above.

•	On the HTR 2, simultaneously press-and-hold [DVD] and		; the Learn LED turns steady green.
•	Press the HTR 2’s	(pause) key; the Learn LED turns amber.

•Press-and-hold the DVD player’s remote’s pause key; the HTR 2’s Learn LED flickers amber and then turns solid green. The command is learned.

•Press [DVD] again to exit the learning mode.

LIBRARY MODE

To enter the library mode, press and hold a device selector key and the AV Preset key for 3 seconds until the status LED turns green. While in Library mode you can cycle through and test the different pre- programmed tables in the remote to find if there is an appropriate table for your device. The several ways of navigating the Library tables are described below. The Learn LED will flash twice when all available tables have been transmitted.

DIGIT KEYS

The digit keys (0 - 9) can be used to directly select one of the tables. Enter the 3 digit table number. After pressing the third digit the HTR 2 will automatically transmit the Power Off command as a test to be sure you have selected the correct table.

CURSOR UP / CURSOR DOWN

The Cursor Up / Cursor Down keys can be used to cycle through the available tables. The HTR 2 will transmit a test (Power Off) command after each press of the Cursor key. Holding down one of the Cursor keys will cycle through all the available library tables at the rate of two per second, allowing you to quickly find the correct table from the available tables.

NOTE

You can change the command transmitted for the test. If you press a key that is not used for anything else in library mode, that command will be transmitted. Any subsequent test commands resulting from changing tables will then use that command which you last pressed. This can be helpful with some devices that do not have a standby mode, in which case the code searches do not work. For example some CD players may not have a power off command, and you may want to use Play as your test command instead.

32