1.2 Hardware Installation

This procedure is performed only for Full Device Server software.

1.2.1 Fax Modem Devic e

A Class II fax modem device is required for use with the CompuFax product. The MultiTech MT2834ZDX fax modem (19,200 data/ 14,400 fax) has been tested for performance and reliability, and is the recommended modem device.

1.2.2 Modem Cabling

A standard serial modem cable can be used to connect the modem to the terminal server (LAT) or hard-wired terminal port (TX, TT, etc.). The following signal lines must be connected:

Pin 2 Transmit

Pin 3 Receive

Pin 7 Signal Ground

1.2.3 Term inal Port Charac t erist ic s

To ensure transmission of files via CompuFax, the terminal port or LAT port characteristics must be configured correctly. These terminal parameters will be the same whether the modem device is connected to a DEC server or to a direct-connect port (TX, TT, etc.). Use the examples shown here as the proper setting of the port characteristics.

$ SHOW TERMINAL

Terminal: _LTA9008: Device_Type: Unknown Owner: Fax Server

Username: SYSTEM

LAT Server/ Port: DS100/ PORT_8

Input: 19200 LFfill: 0 Width: 80 Parity: None

Output: 19200 CRfill: 0 Page: 24

1--2 CompuFax Installation

Terminal Characteristics:

Interactive No Echo Type_ahead No Escape

Hostsync TTsync Lowercase Tab

No Wrap Scope No Remote Eight-bit

No Broadcast No Readsync Form Fulldup

No Modem No Local_echo No Autobaud Hangup

No Brdcstmbx No DMA Altypeahd Set_speed

No Commsync No Line Editing Overstrike editing No Fallback

No Dialup No Secure server No Disconnect Pasthru

No Syspassword No SIXEL Graphics No Soft Characters No Printer Port

Numeric Keypad No ANSI_CRT No Regis No Block_mode

No Advanced_video No Edit_mode No DEC_CRT No DEC_CRT2

No DEC_CRT3 No DEC_CRT4 VMS Style Input

2

Page 16
Image 16
NDC comm CompuFax user manual Hardware Installation, Fax Modem Devic e, Modem Cabling, Term inal Port Charac t erist ic s