1.2.4 Server Port Charac t erist ic s

$ MCR NCP

NCP> Connect NODE nodename

Local> SHOW PORT n (n = port number) Port 8: (Remote)

Character Size: 8 Input Speed: 19200

Flow Control: XON Output Speed: 19200

Parity: None

Access: Remote Local Switch: None

Backwards Switch: None Name: PORT_8

Break: Disabled Session Limit: 4

Forwards Switch: None Type: ANSI Preferred Service:

Authorized Groups: 0

(Current) Groups: 0 Enabled Characteristics:

Autoconnect, Autoprompt, Input Flow Control, Loss Notification, Message Codes, Output Flow Control, Verification

1.2.5 Mult iple Syst em s

The CompuFax software is shipped as a saveset on tape. If you plan to load the software on multiple systems, you may find the installation will proceed faster if the saveset is copied from the distribution media to disk, moved to the designated systems and then installed from disk. For multiple systems follow the steps listed here:

Create a temporary target directory in which to load the files: CompuFax Installation 1—3

$ CREATE/ DIRECTORY target-directory

Move to the target directory you just created: $ SET DEFAULT target-directory

Mount the tape drive unit for reading: $ MOUNT tape-drive: NDC

Move the savesets from tape to disk using the command below. Substitute the correct product name; FAX031.A for a VAX system or FAX_AXP031.A for an Alpha AXP system.

$ COPY tape-drive:product [ ]

1.3 Software Installation

1.3.1 Evaluat ion Wit hout Modem

If you are planning only to evaluate the product without the use of a modem device or any fax hardware, please install the product as indicated in the procedure below and enter 'No' when prompted for the modem. CompuFax will automatically configure the software accordingly for a null device. Then, proceed to the section entitled Section 1.4.2.

3

Page 17
Image 17
NDC comm CompuFax Software Installation, Server Port Charac t erist ic s, Mult iple Syst em s, Evaluat ion Wit hout Modem