Contents | NEC PD75P308 guide

μPD75P308

CONTENTS


1.	PIN FUNCTIONS				5
	1.1	PORT PINS			5
	1.2	NON PORT PINS			6
	1.3	PIN INPUT/OUTPUT CIRCUITS			7

★	1.4	NOTES ON USING P00/INT4 AND	RESET	.....................................................................................PINS
2.	DIFFERENCES BETWEEN μPD75P308 AND μPD75308				10
3.	WRITING AND VERIFYING PROM (PROGRAM MEMORY)				11
	3.1	OPERATION MODES FOR WRITING/VERIFYING PROGRAM MEMORY			11
	3.2	PROGRAM MEMORY WRITE PROCEDURE			12
	3.3	PROGRAM MEMORY READ PROCEDURE			13
	3.4	ERASURE (μPD75P308K ONLY)			14
4.	ELECTRICAL SPECIFICATIONS				15
5.	PACKAGE DRAWINGS				28
6.	RECOMMENDED SOLDERING CONDITIONS				30
APPENDIX A. DEVELOPMENT TOOLS					31
★ APPENDIX B. RELATED DOCUMENTS					32

4

Image 4

NEC PD75P308 user manual Contents

Contents

Features DescriptionOrdering Information Quality Grade PIN Configuration ΜPD75P308 Block Diagram Contents Port Pins PIN Functions NON Port Pins PIN INPUT/OUTPUT Circuits Schmitt trigger input with hysteresis characteristicsInput buffer of Cmos standard Type F-B COMIN/OUT SEG Connect capacitor between VDD and P00/INT4, Reset pin Type M-C Differences Between μPD75P308 and μPD75308 Eprom Program memory address 0 clear mode +12.5 Write mode Verify mode Program inhibit mode Or HWriting and Verifying Prom Program Memory Operation Modes for WRITING/VERIFYING Program Memory Program Memory Write Procedure VDD+1 Program Memory Read Procedure Erasure μPD75P308K only Electrical Specifications Absolute Maximum Ratings Ta = 25C Main System Clock Oscillator Circuit Characteristics Ta = -10 to +70C, VDD = 5 to ±5Recommended Oscillation Circuit Constants Main System Clock Ceramic Oscillator Ta = -10 to +70C Capacitance Ta = 25C, VDD = 0 DC Characteristics Ta = -10 to +70C, VDD = 5V ±5% Interrupt mode register IM0 AC Characteristics Ta = -10 to + 70C, VDD = 5V ±5%Operation Other Than Serial Transfer Serial Transfer Operation SBI Mode SCK internal clock output master SBI Mode SCK external clock output master Clock Timing AC Timing Test Point excluding X1 and XT1 inputsTI0 Timing Serial Transfer Timing THREE-LINE Serial I/O Mode TWO-LINE Serial I/O Mode Serial Transfer Timing BUS Release Signal Transfer Command Signal TransferReset Input Timing Interrupt Input Timing Ta = -10 to +70C Data Retention Timing releasing Stop mode by ResetBTM3 BTM2 BTM1 BTM0 Other than X1 or Program Memory Read Timing Program Memory Write TimingMD0 MD1 Package Drawings PIN Plastic QFP 14×20 PIN Ceramic Wqfn Millimeters Inches ΜPD75P308GF-3B9 80-pin plastic QFP 14 x 20 mm Recommended Soldering ConditionsVPS Appendix A. Development Tools Prom writing tools Appendix B. Related Documents Processing of Unused Pins Cmos Devices only Static Electricity ALL MOS DevicesStatus Before Initialization ALL MOS Devices Fix the input level of Cmos devices Memo