NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
• b only – Supports only 802.11b. The default is g and b.
7.Click Apply to save your settings.
Verify your connection by clicking Site Survey. The ID radio button of your wireless connection should be enabled. You can also click Information. The Associated AP should show the MAC address of the remote AP. If no connection has been made, a “no association” message will display.
.
Table 4-1. Site Survey Fields
Field | Description |
|
|
ID | Identifies a network that you can connect to or that you are connected to. |
|
|
SSID | The Service Set Identifier (SSID) of the access point or peer device. Note that, as a security |
| measure, some wireless access points do not broadcast their SSID. In such cases, the SSID |
| field will be blank even though the rest of the information will still be displayed. |
|
|
Security | Identifies the wireless network security type. In order to connect to this network you must |
| have the same security type enabled. |
|
|
Mode | Identifies the type of wireless |
| Hoc) |
|
|
Channel | Identifies the |
|
|
Signal | Identifies the signal strength of the communications. |
|
|
The scenario below illustrates WG602v4 in Client Mode where multiple devices are connected behind the wired Ethernet side (PC1 and Printer). The WG602v4 Client, with a Network Type of Infrastructure, acts like a wireless bridge between two wired LANs. The WG602v4, in AP mode on the other LAN, provides access to the Internet.
Advanced Configuration |
