NETGEAR WG602V4 manual Configuring Wireless Multi-Point Bridging

NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual

3.Verify connectivity across the network.

If you enabled wireless client association on both APs, a computer on either AP should be able to connect to the Internet or share files and printers of any other PCs or servers connected to the network.

Configuring Wireless Multi-Point Bridging

In this mode, the WG602v4 will communicate with up to four bridge-mode wireless access points by entering the MAC address (physical address) of each of the bridge-mode APs in the fields provided. In addition, if you check the Enable Wireless Client Association checkbox, wireless clients will also be serviced by this access point. Each wireless access point you enter will be listed in the Wireless Remote Access Point List.

To configure wireless Multi-point Bridging:

1.Open a web browser and log into the WG602v4 using the addressing scheme you have set up

4-4 Advanced Configuration

v1.0, June 2007