USER MANUAL
ENGLISH
AFTER USING THE MACHINE
After working, before leaving the machine:
–Turn on the filter shaker shortly, by pressing the upper part of the switch (66).
–Empty the hopper (4) (see the procedure in the previous paragraph).
–Lift the main broom with the lever (80).
–Lift the side brooms with the levers (77) and (78).
–Turn off the machine by turning the ignition key (69) to “0”, then remove it.
–Engage the parking brake by pressing the pedal (82), then engage the brake lock control lever (75).
PUSHING/TOWING THE MACHINE
To easily push/tow the machine when it is off, proceed as follows:
–Turn off the machine by turning the ignition key (69) to “0”.
–Open the hood (23) and fasten it with the support rod (55).
–Remove the screw (37).
–Remove the support rod (55) and close the hood (23).
–Push or tow the machine.
–After pushing/towing the machine, install the screw (37).
WORKING LIGHT ADJUSTMENT (optional)
If necessary, adjust the working light beam aiming (9) with the screws (21).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1.Check that the machine storage area is dry and clean.
2.Disconnect the negative connector
3.Handle the petrol engine (29) as shown in the relevant Manual.
FIRST PERIOD OF USE
After the first 5 hours perform the following procedures:
1.Check the fastening and connecting parts for proper tightening; check the visible parts for integrity and leakages.
2.Change the engine oil (see the procedure in Maintenance chapter).
FLOORTEC R 680 P |
17
