Nortel Networks 1002rp manual To connect the mouse, keyboard, and monitor to the server

Installing the server and connecting the peripheral devices Standard 1.07

To connect the mouse, keyboard, and monitor to the server

1Place the monitor, keyboard, and mouse in the same location as the server.

2Plug the keyboard/mouse dual cable into the PS/2 connector on the SBC card faceplate (see “Rear panel connectors” on page 65).

3Plug the keyboard and mouse into the appropriate connectors on the keyboard/mouse dual cable.

4Plug the monitor into the monitor connector on the SBC card. Tighten the screws on the connector.

5Ensure that a single-point ground reference is available for all the power outlets serving the CallPilot server and its peripherals. Before the CallPilot server installation, a qualified electrician must implement the single-point ground reference requirement between the power outlets of the CallPilot server and the power outlets of the switch.

6Connect the power cord to the monitor and plug the other end into a wall receptacle or power bar.

Note: Ensure that the power source is consistent with the SBC for all ancillary equipment.

7Turn on the monitor.

To connect the modem to the server

1Ensure that the modem AC power cord is not plugged in.

2Connect the large 25-pin male connector to the back of the modem. Tighten the connector screws.

3Connect the 9-pin female connector to COM1 at the rear of the server. Tighten the connector screws.

4Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.

5Connect the other end of the telephone cable to the RJ-11 jack in the wall.

66 CallPilot