Installing the server and connecting the peripheral devices | Standard 1.07 |
Connecting the server to the ELAN
Introduction
ATTENTION |
| |
This section applies only if the 1002rp server connects | ||
| ||
| to a Meridian 1 switch or Succession 1000 system. |
Connect the CallPilot server to the Meridian 1 switch or Succession 1000 system using the ELAN.
ATTENTION |
| |
For important considerations about using the ELAN in | ||
| ||
| your network, see the Planning and Engineering Guide | |
| ||
ATTENTION |
| |
To comply with EMC radiation requirements, a Class A | ||
| ||
| hub must be located 10 m (33 ft.) away from the 1002rp | |
| server. Shielded Ethernet cables must be used. |
Media Access Control address
The Media Access Control (MAC) address is a unique number assigned to network cards and controllers. The procedure below asks you to record the ELAN MAC address. The MAC address is recorded on a label affixed to the back of the chassis.
To connect the server to the ELAN
1See the diagram on page 65 to locate the ELAN Ethernet connector.
2Locate the MAC address label on the back of the chassis that identifies the ELAN controller MAC address.
68 | CallPilot |
